Table of Contents
Advertisement
Appendix C Setting Up TCP/IP
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the
antenna and users
(for example: This module will be bundling into Broadband product such as Wireless ADSL/Wireless Router or AP/Wireless Cable
Modem/ Notebook with antenna mounted around LCD
panel).
The final end product must be labeled in a visible area with the following:
"Contains TX
FCC ID: K7SF5D76341".
Manual Information That Must be Included
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the users manual
of the end product which integrate this module.
The users manual for OEM integrators must include the following information in a prominent location " IMPORTANT NOTE: To comply with FCC
RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
43
Advertisement
Table of Contents
