Table of Contents
Advertisement
3 Printer operation
3 Printer operation
This chapter provides information about printer operation.
Printing Media Calibration &
3.1
Configuration
Before connecting the printer to your computer, to make sure that the
printer works properly, conduct media calibration and print a self-test/
configuration label.
1. Make sure the media is properly loaded, the print module is closed, and
the printer's power switch is set to the OFF position.
2. Press and hold the FEED button, and turn on the printer.
3. Media Calibration will be performed while the printer automatically
feeds the label stock for a certain length; then the printer motor
suspends for one second and then prints out configuration/ self-test
labels. Release the FEED button as soon as printer starts to print.
Note:
If printer is with Argox PPLB printer language, printer will enter Dump mode
after printing configuration. In Dump mode, all characters will be printed in 2
columns: the right shows characters received from your system, and the left are
the corresponding hexadecimal values of the characters. It allows users or
engineers to verify and debug the program.
To return to normal operation mode from Dump mode, press the FEED
button again. Another way is to turn off printer power, and then restart
printer.
Your configuration label should look like this:
24
Media sensor calibration
Advertisement
Table of Contents
