Setup - Greenlee 555 Instruction Manual

Setup

Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection can
result in serious eye injury from
flying debris.
Unplug the bender before changing accessories.
Accidental start-up can result in serious injury.
1. Slide the appropriate bending shoe onto the shaft of
the main sprocket, as shown. Align the four drive
studs on the back of the shoe with the four holes in
the main sprocket.
Note: 1-1/2" and 2" EMT and IMC bending shoes
have only three drive studs.
Installing a Bending Shoe
Greenlee Textron / Subsidiary of Textron Inc.
®
555 Deluxe Electric Bender
2. Mount the appropriate support unit onto the leg of
the bender and install the hinge pin, as shown.
Roller Support Unit Installed
3. Mark the conduit. See the decals on the bender or
the Additional Bending Instructions section of this
manual.
4. Place the bender in either the vertical or horizontal
bending position.
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
8
Install pin.