Troubleshooting - Greenlee 555 Instruction Manual

Troubleshooting

PROBLEM
Bender will not operate.
Bends are overbent a few
degrees.
Bends are underbent a few
degrees.
Greenlee Textron / Subsidiary of Textron Inc.
®
555 Deluxe Electric Bender
PROBABLE CAUSE
No voltage.
Too much squeeze on 1-1/2" or 2"
EMT or IMC conduit.
Unusual conduit characteristics.
Too little squeeze on 1-1/2" or 2"
EMT or IMC conduit.
Unusual conduit characteristics.
Check supply voltage circuit operation.
Check that switch is on.
Back squeeze off per adjustment
instructions.
Bend smaller angle to compensate.
Increase squeeze per adjustment
instructions.
Bend larger angle to compensate.
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
27
POSSIBLE REMEDY