Chapter 4 Adjustments And Updating Of Settings, Required After Parts Replacement; If You Replace The Main Pcb Assy - Brother HL-2230 Service Manual

CHAPTER 4 ADJUSTMENTS AND UPDATING OF SETTINGS,
REQUIRED AFTER PARTS REPLACEMENT
1.

IF YOU REPLACE THE MAIN PCB ASSY

<What to do when replacing the main PCB ASSY>
• Rewriting the Firmware (Main Program)
• Setting the default paper size
• Setting the serial number
• Inputting the adjusted value of the laser unit
Note:
• Since the counters are reset when the main PCB ASSY is replaced, the consumables
and/ or periodical replacement parts might reach the end of the life before the
message is displayed.
<What you need to prepare>
(1) A USB cable
(2) Computer (Windows ® XP or later)
Create folder, for example "hl2200" folder on the C drive.
(3) Service Setting Tool (brusbn.zip)
Copy it into the "hl2200" folder that has been created on the C drive. Extract the copied
file and run "BrUsbsn.exe" file by double-clicking.
(4) Download Utility (FILEDG32.EXE)
Copy it into the "hl2200" folder that has been created on the C drive.
(5) Maintenance Driver (MaintenanceDriver.zip)
If Maintenance Printer Driver is not installed to your PC, copy it into the "hl2200" folder
that has been created on the C drive. Extract the copied file. (Refer to
THE MAINTENANCE PRINTER DRIVER"
(6) Firmware
Main Program :
LZXXXX_$.blf
(7) Setting file of the default paper size
DefaultPaperA4.pjl (A4 size)
DefaultPaperLtr.pjl (Letter size)
DefaultPaperIsr.pjl (A4 size, Israeli font for Israel)
LZXXXX: First six digits are a parts number of the firmware.
$: Alphabet representing the revision of the firmware
4-1
in APPENDIX 3.)
"INSTALLING
Confidential