Chapter 4 Adjusting And Updating Settings As Required After Parts Replacement; If You Replace The Main Pcb Assy - Brother HL-2290 Service Manual

CHAPTER 4 ADJUSTING AND UPDATING

1. IF YOU REPLACE THE MAIN PCB ASSY

 What to do after replacement
• Setting by Spec
• Installing Firmware (Sub firmware and main firmware)
• Setting Serial Number and Entering Adjusted Value of Laser Unit
 What you need to prepare
(1) One USB cable
(2) Create a temporary folder on the C drive of the computer (Windows
(3) Service setting tool (SvSettingTool.exe)
Copy this file into the temporary folder created on the C drive.
* .NET Framework 4.5.2 or later
(4) Download utility (FILEDG32.EXE)
Copy this file into the temporary folder created on the C drive.
(5) Maintenance printer driver (MaintenanceDriver.zip)
When the maintenance printer driver is not installed on the computer, copy this file into
the temporary folder created on the C drive, and extract the copied file. Refer to
"APPENDIX 3 INSTALLING THE MAINTENANCE PRINTER DRIVER"
installation procedure.
(6) Firmware
Sub firmware
Main firmware
(7) Memory access tool (MemoryAccessTool.exe)
SETTINGS AS REQUIRED
AFTER PARTS REPLACEMENT
of Microsoft is needed to use SvSettingTool.
djf or upd file
(ex. DXXXXX_A.djf or DXXXXX _A.upd)
djf or upd file
(ex. DXXXXX_A.djf or DXXXXX _A.upd)
4-1
®
XP or later).
for the
Confidential