Faulty Registration; Dark - Brother HL-2230 Service Manual

4.2.2 Faulty registration

Step
Adjusted value of the laser unit
1 mistake
Registration rear actuator catching
2
on some position

4.2.3 Dark

Step
Dirt on the electrodes of the drum
1
unit and the printer body
High voltage power supply PCB
2
ASSY failure
3 Main PCB failure
4 Laser unit failure
User Check
• Check that the appropriate media type is selected in the
driver.
Cause
User Check
• Check the printer's environment. High temperature and high
humidity or low temperature and low humidity conditions can cause
this problem.
• Adjust the density by the Density Adjustment.
• Clean the corona wire of drum unit.
• Replace the drum unit with a new one.
• Replace the toner cartridge with a new one. If remove the used
toner cartridge and replace a relatively new used toner cartridge,
this case is caused.
Cause
2-31
Remedy
Refer to "2.1 Inputting the adjusted value of
the laser unit" (Chapter 4), and enter the
adjusted value of the laser unit again.
Correct catching of the registration rear
actuator.
Remedy
Clean the electrodes of the drum unit and
printer body. (Refer to Fig. 2-8, Fig.
Replace the high voltage power supply
PCB ASSY.
Replace the main PCB ASSY.
Replace the laser unit.
2-9.)
Confidential