Nwa1123-Ac Hd, Nwa5123-Ac Hd And Wac6303D-S - ZyXEL Communications WAC Series User Manual

The following table describes the LEDs.
Table 12 WAC5302D-S LEDs
LED
PWR/SYS
Management
UPLINK
WLAN
WLAN
LAN

1.6.6 NWA1123-AC HD, NWA5123-AC HD and WAC6303D-S

The following are the LED descriptions for your NWA/WAC.
Chapter 1 Introduction
COLOR STATUS
Red Slow Blinking (On for 1s,
Off for 1s)
Green On
Red Off
Green On
Red On
Green Off
Red Fast Blinking (on for
50ms, Off for 50ms)
Green Off
Red Slow Blinking (blink for 3
times, Off for 3s)
Green Off
Red Slow Blinking (blink for 2
times, Off for 3s)
Green Off
Green On
Slow Blinking (blink for 3
times, Off for 3s)
Off
Amber/ On
Green
Blinking
Off
Green On
Off
Green On
Off
Amber/ On
Green
Blinking
Off
NWA / WAC Series User's Guide
DESCRIPTION
The WAC is booting up.
The WAC is ready for use.
There is system error and the WAC cannot boot up, or the
WAC suffered a system failure.
The WAC is doing firmware upgrade.
The Uplink port is disconnected.
The wireless module of the WAC is disabled or failed.
The WAC AP is managed by a controller.
The WAC AP is searching (discovery) for a controller.
The WAC AP is in standalone mode.
Amber - The port is operating as a 10/100-Mbps
connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
The WAC is sending/receiving data through the port.
The port is not connected.
The 2.4 GHz WLAN is active.
The 2.4 GHz WLAN is not active.
The 5 GHz WLAN is active.
The 5 GHz WLAN is not active.
Amber - The port is operating as a 10/100-Mbps
connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
The LAN port is sending/receiving data through the port.
The LAN port is not connected.
32