Table of Contents
Advertisement
6.
You have successfully assigned a new password
to the projector. Remember to enter the new
password next time the projector is started.
7.
To leave the OSD menu, press MENU/EXIT.
Disabling the password function
To disable password protection, go back to the System Setup: Advanced > Security
Settings > Change Security Settings menu after opening the OSD menu system. Press
MODE/ENTER. The message "INPUT PASSWORD" appears. Enter the current
password.
1.
If the password is correct, the OSD menu returns to the Security Settings. Press
▼ highlight Power On Lock and press ◄/► to select Off. You will not have to
enter the password next time you turn on the projector.
Press ▼ to highlight Web Control Lock and press ◄/► to select Off. The Web
Control Lock function is released and the projector settings can be change via the
Projector Network System.
2.
If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'INPUT PASSWORD' displays for your retry. You can
press MENU/EXIT to cancel the change or try another password.
Though the password function is disabled, you need to keep the old password in hand should you
ever need to re-activate the password function by entering the old password.
Switching input signal
The projector can be connected to multiple devices at the same time. However, it can only
display one full screen at a time.
Be sure the Quick Auto Search function in the Source menu is On (which is the
default of this projector) if you want the projector to automatically search for the signals.
You can also manually cycle through the available input signals.
1.
Press SOURCE on the projector or press input source directly from the remote
control. A source selection bar displays.
2.
Press ▲/▼ until your desired signal is selected and press MODE/ENTER.
Once detected, the selected source information will display on the screen for
seconds. If there is multiple equipment connected to the projector, repeat steps 1-2
to search for another signal.
•
The brightness level of the projected image will change accordingly when you switch
between different input signals. Data (graphic) "PC" presentations using mostly static
images are generally brighter than "Video" using mostly moving images (movies).
•
For best display picture results, you should select and use an input signal which outputs at
this resolution. Any other resolutions will be scaled by the projector depending upon the
'aspect ratio' setting, which may cause some image distortion or loss of picture clarity. See
"Selecting the aspect ratio" on page 35
Operation
for details.
Password Changed
33
Advertisement
Table of Contents
