Table of Contents
Advertisement
FUNCTION
Standby
Settings
Network
settings
Reset All
Settings
Operation
DESCRIPTION
Network
Enable Network Standby Mode
To enable or disable the network standby mode after the projector
is automatically or manually turned off.
•
On: The projector will maintain at network standby mode with
less than 6W power consumption.
•
Off: The projector will maintain at normal standby mode with
less than 0.5W power consumption.
Auto Disable Network standby mode
To enable or disable the auto switch from network standby mode to
non-network standby mode after a period of time. (This setting
should be grayed out when Enable network standby mode is off.)
•
Never:To disable the auto switch function. The projector will
maintain at network standby mode with less than 6W power
consumption.
•
20 min / 1 hr / 3 hr / 6 hr: The projector will be switched to
non-network standby mode after 20 minutes / 1 hour / 3 hours /
6 hours
Monitor Out
Selecting On enables the function. The projector can output a VGA
signal when it is in standby mode and the COMPUTER 1 jack is
correctly connected to devices. See
how to make the connection.
Audio Pass Through
The projector can play sound when it is in standby mode and the
corresponding jacks are correctly connected to devices. Press ◄/►
to choose the source that you wish to use. See
22
for how to make the connection.
Enabling this function slightly increases the standby power
consumption.
MHL Charging
Selecting On enable the function when device connected to
HDMI-1/MHL jack.
Wired LAN
AMX Device Discovery
When AMX Device Discovery is On, the projector can be
detected by AMX controller.
MAC Address
Displays the mac address for this projector.
Returns all settings to the factory preset values.
The following settings will still remain: Position, Phase, H. Size,
Projector Installation, Language, High Altitude Mode, Security
Settings, Baud Rate.
"Connection" on page 22
"Connection" on page
for
59
Advertisement
Table of Contents
