Table of Contents
Advertisement
Part names and their functions
INDOOR UNIT
9
10
14
CAUTION
Before opening the front panel, be sure to
stop the operation and turn the breaker OFF.
Do not touch the metal parts on the inside
of the indoor unit, as it may result in injury.
1. Titanium Apatite Photocatalytic
Air-Purifying Filter:
• These filters are attached to the inside
of the air filters.
2. Air outlet
3. Display
4. Front panel
5. Louvers (vertical blades)
• The louvers are inside of the air outlet.
6. Air inlet
7. Air filter
8. Flap (horizontal blade)
9. Cool mode lamp
10. Heat mode lamp
11. Dry mode lamp
12. Run lamp
13. LED display
14. Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refers to the following table.
Temperature
Model
Mode
setting
COOLING
AUTO
ONLY
HEAT
AUTO
PUMP
• This switch is useful when the remote controller
is missing.
15.Signal receiver:
• It receives signals from the remote controller.
• When the unit receives a signal, you will hear
a short beep.
•Settings changed.....beep
16.Air outlet selection switch
17.Room temperature sensor:
•It senses the air temperature around the unit.
•
•
Air flow rate
AUTO
25℃
25℃
AUTO
3
3
8
11
12
13
7
4
15
2
Air outlet selection switch
This setting blows air from
16
upper outlet only.
This setting automatically
decides a blow pattern
depending on mode and
conditions.
• This setting is recommended.
• The unit is shipped from the
factory with this setting.
Indoor unit
wiring terminal
N(1) 2
3
YELLOW/
BU
BK
BN
GREEN
7
OPERATION INSTRUCTIONS
1
2
5
Opening the Front Panel
6
17
Advertisement
Table of Contents
