Table of Contents
Advertisement
Installation of indoor unit
Installing indoor unit
1.Preparation
Open the front panel, remove the 4 screws and dis-
mount the front grille while pulling it forward.
Follow the arrows to disengage the clasps on the
front case to remove it.
Follow the procedure below when removing the slit
portions.
For Moldings
Remove the pillars. (Remove the slit portions on the
bottom frame using nippers.)
For Side Piping
Remove the pillars.
1)Remove the 7screws.
2)Remove the upper casing (2 tabs).
3)Remove the left and right casings (2 tabs on each
side ).
4)Remove the slit portions on the bottom frame and
casings using nippers .
5)Return by following the steps in reverse order(3>2>
1).
2.Installation
Secure using 6 screws for floor installations.(Do not forget to secure to the rear wall.)
For wall installations, secure the mounting plate using 5 screws and the indoor unit using 4 screws.
Front panel
3)Side
casings
Casing
Remove the pillar
23
INSTALLATION INSTRUCTIONS
3 tabs
Remove 4 screws
2)Upper casing
Remove 7 screws
Casing
Front
grille
Remove
front grille
Open the front panel
3)Side
casings
Remove the pillar
Bottom frame
Casing
Remove the pillar
Advertisement
Table of Contents
