Sharp AF-S80CX Service Manual page 8

AF-S80CX
ENERGY SAVER
During normal operation, the thermostat automatically controls cooling and the fan runs
continuously. When the ENERGY SAVER is selected, the thermostat automatically controls
cooling and the fan automatically stops when the compressor is not operating. (Fan will stop 30
seconds after the compressor stops. After the fan stops, the fan is programmed to rotate for
approx. 2 minutes to detect room temperature. This will occur within a 20 min time span.)
COOL / FAN TEMP
SELECTOR
ENERGY SAVER pad
ENERGY SAVER indicator
NOTE: ENERGY SAVER cannot be set during fan only (HIGH FAN, MED FAN, LOW FAN)
operation.
TO CHANGE AIR FLOW DIRECTION
The horizontal louvers are used to adjust the UP / DOWN direction of air flow, and the vertical
louvers are used to adjust the LEFT / RIGHT direction of air flow for uniform and efficient
cooling of the room.
Horizontal louvers
Adjust UP/DOWN air flow
F
hr
ENERGY
TIMER
POWER
ON/OFF SAVER
ON/OFF
During cooling operation
1
Touch ENERGY SAVER pad.
• ENERGY SAVER indicator will light.
2
To cancel, touch ENERGY SAVER
pad again.
• ENERGY SAVER indicator will go
off.
Vertical louvers
Adjust LEFT/RIGHT air flow
8
Lever