Table of Contents
Advertisement
Attention
f Be careful not to block the intake/exhaust vents with your hands or any objects when adjusting the adjustable feet while the light source is
on. ( x page 25)
Adjusting the focus and the shift
Using the control panel
1)
Press the <LENS> button on the control panel.
f The scree will switch between the adjustment screens of [FOCUS] and [SHIFT] every time the button is
pressed.
2)
Select each adjustment item and press asqw to adjust.
Using the remote control
1)
Press the lens buttons (<FOCUS>, <SHIFT>) on the remote control.
f <FOCUS> button: Adjusts focus.
f <SHIFT> button: Adjusts shift.
2)
Select each adjustment item and press asqw to adjust.
CAUTION
Do not insert the hand into the opening around the lens while performing the lens shift operation.
Your hand may be caught in between, resulting in injury.
Note
f The adjustment can be performed faster by holding down asqw for approximately three seconds or longer while adjusting the focus.
f The adjustment can be performed faster by holding down asqw for approximately six seconds or longer while adjusting the shift.
f It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
Only [FOCUS] is displayed in yellow so that the displayed menu item can be recognized by color, even when the displayed characters are
unreadable due to incorrect focus. (Factory default)
f The displayed color of [FOCUS] differs depending on the setting of the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [OSD
COLOR].
f The projector will not operate by pressing the <ZOOM> button.
f When the projector is switched off during the shift adjustment, lens calibration needs to be performed the next time the projector is switched
on. ( x page 112)
f When the main power is switched off during the shift adjustment, the lens calibration error screen is displayed during the next shift
adjustment. Execute the [PROJECTOR SETUP] menu → [LENS CALIBRATION].
f When the lens calibration error is displayed even though [LENS CALIBRATION] was executed, ask your dealer to repair the unit.
Moving the lens position to the home position
To move the lens position to the home position, perform the following procedure.
1)
Press the <DEFAULT> button on the remote control while the shift adjustment screen is displayed.
f The [HOME POSITION] screen is displayed.
52 - ENGLISH
Chapter 3 Basic Operations — Projecting
LENS
HOME POSITION
EXECUTE
ENTER
CANCEL
MENU
Maximum adjustable range
Adjustable feet: 35 mm (1-3/8") each
Advertisement
Table of Contents
