Minolta MINOLTAFAX 1600 Operator's Manual page 15

xiv
Safety Information
USER INSTRUCTIONS (For New Zealand)
Warnings
• Immediately disconnect the equipment should it become physically damaged, and arrange for its dis-
posal or repair before reconnecting.
• Disconnect the Telecom Network connection before disconnecting the Power connection prior to relo-
cating the equipment, and reconnect the Power first.
• This equipment may not necessarily provide for the effective hand-over of a call to or from a tele-
phone connected to the same line.
• Not all Standard telephones will respond to incoming ringing when connected to the extension socket
at the rear of the equipment.
• As there is no audio monitoring of dialing or calling procedures, please double check that you are dial-
ing a valid fax number, especially in the event of no response to redials.
WARNING NOTICE:
No '111' or other calls can be made from this device during a mains power failure
Use of pulse dialing, when this equipment is connected to the same line as other equipment, may
give rise to bell tinkle or noise and may also cause a false answer condition. Should such prob-
lems occur, the user should not contact the telecom faults service.
OZONE RELEASE (For all Users)
During printer operation, a small quantity of ozone is released. This amount is not large enough to
harm being adversely. However, be sure the room where the fax is being used has adequate ventila-
tion, especially if you are printing a high volume of materials, or if the fax is being used continuously
over a long period.