Fan Jumper Settings - Supero SC835TQ User Manual

SC835 Chassis Manual
Jumper
1-2: Reset
JP35
2-3: No reset
Socket
JP18 Connected to front panel
*The buzzer sound indicates that a condition requiring immediate attention has
occurred.
The buzzer alarm is triggered by the following conditions:
1. Hard drive failure
2. Fan failure
3. System temperature over 45º Celsius.

Fan Jumper Settings

This backplane can use up to three fans. To utilize each fan, you must configure
both jumpers as instructed below.
Jumper
1-2: With fan
JP61
2-3: No fan
1-2: With fan
JP97
2-3: No fan
1-2: With fan
JP62
2-3: No fan
1-2: With fan
JP98
2-3: No fan
1-2: With fan
JP63
2-3: No fan
1-2: With fan
JP99
2-3: No fan
Jumper Settings
Jumper Settings
Socket Settings
Socket Setting
Fan Jumper Settings
Jumper Settings
MG9072 chip reset
Buzzer reset*
Press once to disable buzzer
Press twice to enable buzzer
FAN #1 select
FAN #1 select
FAN #2 select
FAN #2 select
FAN #3 select
FAN #3 select
C-8
Note
Note
Note