Change The Remote Access Pin Code; Charge The Handset; Check The Battery Level - Philips D605 Series Extended User Documentation

Set the date and time format
1
Select [Menu] >
press [OK] to confirm.
2
Select [Date format] or [Time format].
3
to select [DD-MM-YYYY] or
Press /
[MM-DD-YYYY] as the date display, and
[12 Hours] or [24 Hours] as the time
display. Then press [OK] to confirm.
» The setting is saved.
Note
•
The date and time format setting is country dependent.
Change the remote access
PIN code
Note
•
The default answering machine remote access PIN
code is 0000 and it is important to change it to ensure
the security.
•
This feature is available only for D605.
1
Select [Menu] >
[Change PIN], then press [OK] to confirm.
2
Enter the old PIN/passcode, then press
[OK] to confirm.
3
Enter the new PIN/passcode, then press
[OK] to confirm.
4
Enter the new PIN/passcode again, then
press [Save] to confirm.
» The setting is saved.

Charge the handset

Place the handset on the base station to
charge the handset. When the handset is
placed correctly on the base station, you hear
12 EN
> [Date & time], then
> [Remote access] >
a docking tone (see 'Set the docking tone' on
page 27).
» The handset starts charging.
Note
•
Charge the batteries for 8 hours before first use.
•
If the handset becomes warm when the batteries are
being charged, it is normal.
•
Over time, capacity of batteries decreases. This is a
normal battery behavior.
Your phone is now ready to use.

Check the battery level

The battery icon displays the current battery
level.
When the handset is off the base
station/charger, the bars indicate
the battery level (from full to low).
When the handset is on the base
station/charger, the bars flash until
charging is complete.
The empty battery icon flashes.
The battery is low and needs
recharging.
If you are on the phone, you hear warning
tones when the batteries are almost empty.
The handset turns off when the batteries are
completely empty.