Adjusting The Projector's Elevator; Adjusting The Zoom And Focus - Dukane ImagePro 8964WSS User Manual

Adjusting the projector's elevator

Lengthening or shortening the length
of the elevator feet shifts the projection
position and the projection angle.
Turn the elevator feet each to adjust
their length.
WARNING ►Do not lengthen the elevator feet exceeding 21 mm. The foot
lengthened exceeding the limit may come off and drop the projector down, and
result in an injury or damaging the projector.

Adjusting the zoom and focus

1.
Use the ZOOM ring to adjust the screen size.
2.
Use the FOCUS ring to focus the picture.
3.
Fasten the ZOOM ring by STOPPER so that it cannot loosen.
CAUTION ►Tighten the STOPPER of the ZOOM ring
if you install the projector when the lens faces upward
(+30°~ +150°) or downward (-30°~ -150°). Be careful not to
tighten the STOPPER too tightly. Otherwise it would cause
malfunction in the projector. When you tighten the STOPPER,
the projected screen may move slightly.
Loosen
max. 21mm
Tighten
STOPPER
ZOOM ring
FOCUS ring
Operating
3 3