Gigabyte GA-K8VM800M User Manual page 67

B. Delete Array:
If you want to delete the Array, select Delete Array in the main menu and press Enter. The channel column
will be activated. Select the member of an array that is to be deleted and press Enter. A warning message
will show up, press Y to delete or press N to cancel.
Create Array
Delete Array
Create/Delete Spare
Select Boot Array
Serial Number View
The selected array will be destoried.
Are you sure? Continue? Press Y/N
Channel Drive Name
[*]Serial_Ch0 Master ST3120026AS
[*]Serial_Ch1 Master ST3120026AS
Deleting a disk array will destroy all the data on the disk array except RAID 1 arrays. When a RAID is
deleted, the data on these two hard disk drives will be reserved and become two normal disk drives.
C. Select Boot Array:
You can select a disk array as boot device if you want to boot operating system from an array. Boot disk
array cannot be selected if the operating system does not boot from the disk array. Highlight the Select Boot
Array item; press Enter and the channel column will be activated. Then highlight the target disk array and
press Enter. Press Esc to go back to main menu. If you want to cancel the boot array, select the disk array
that has a star(*) mark and press Enter, its boot setting will be canceled.
Create Array
Delete Array
Create/Delete Spare
Select Boot Array
Serial Number View
Channel Drive Name
[*]Serial_Ch0 Master ST3120026AS
[*]Serial_Ch1 Master ST3120026AS
VIA Tech. VT8237 SATA RAID BIOS Ver 2.41
Delete a RAID array contain
the hard disks attached to
VIA RAID controller
F1
,
Enter : Confirm the selection
ESC
Array Name
ARRAY 0
ARRAY 0
VIA Tech. VT8237 SATA RAID BIOS Ver 2.41
Set/Clear bootable array
F1
,
Enter : Confirm the selection
ESC
Array Name
ARRAY 0
ARRAY 0
- 67 -
: View Array/disk Status
: Move to next item
: Exit
Mode Size(GB) Status
SATA 111.79 Stripe0
SATA 111.79 Stripe1
: View Array/disk Status
: Move to next item
: Exit
Mode Size(GB) Status
SATA 111.79 Boot
SATA 111.79 Boot
Appendix