Gigabyte GA-8IGX User Manual page 26

GA-8IGX Motherboard
J) F_PANEL (2x7 pins jumper)
HD (IDE Hard Disk Active LED)
SPK (Speaker Connector)
RST (Reset Switch)
PD+/PD_G-/PD_Y-(Power LED)
PW (Soft Power Connector)
Please connect the power LED, PC speaker, reset switch and power switch etc of your chassis front
panel to the F_PANEL connector according to the pin assignment above.
Q) NB_FAN (Chip Fan)
1 +12V
GND
14
2
13
1
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
Open: Normal Operation
Close: Reset Hardware System
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 3: LED cathode(-)
Open: Normal Operation
Close: Power On/Off
Please note:
If installed wrong direction, the Chip Fan will not
work. Sometimes will damage the Chip Fan.
(Usually black cable is GND)
2 2