Rip; Multinat - D-Link SL2750BT1 User Manual

Table of Contents

4.4.13

RIP

Choose ADVANCED > Routing and click RIP. The page shown in the following

figure appears. This page is used to select the interfaces on your device that

use RIP and the version of the protocol used.

If you are using this device as a RIP-enabled device to communicate with others

using the routing information protocol, enable RIP and click Apply to save the

settings.

4.4.14

Network address translation (NAT) is the process of modifying network address

information in IP packet headers while in transit across a traffic routing device

for the purpose of remapping a given address space into another. The packets

which source IP address match between "internalStart" and "internalEnd" in the

NAT table come to the router, the router changes source IP of this packet by the

IP address that set between "externalStart" and "externalEnd", then transmit the

packet into Internet.

Choose ADVANCED > MultiNat. The page shown in the following figure

appears.

DSL-2750B User Manual

Table of Contents

Dsl-2750b