Gigabyte GA-6IEM User Manual page 89

STEP 6: Load BIOS defaults.
Normally the system redetects all devices after BIOS has been upgraded. Therefore, we highly
recommend reloading the BIOS defaults after BIOS has been upgraded. This important step
resets everything after the flash.
(1) T ake out the floppy diskette from floppy drive, and then restart the system. The boot up screen will
indicate your motherboard model and current BIOS version.
Ame rica n
Me gat r ends AM I BI OS (C) 1 999 Amer ican Meg at re nd
7VTX F4
Check Syst em Healt h OK
AMD-At hlon(t m)Processor-900MHz
Checking NVRAM...
262144KB
Wait ...
Press F1 t o ent er Dual BI OS Ut ilit y. Press ESC t o quit
Press any key t o cont iune
( C ) American Megat rends I nc.,
63-0001-001199-00101111-071595-VI A_K7-GA7VTX1-F
(2) Don't forget to press <DEL> key to enter BIOS setup again when system is boot up. Use the
arrows to highlight the item "LOAD SETUP DEFAULTS" then press "Enter". System will ask
"Load Setup Defaults (Y/N)?" Press "Y" and "Enter" keys to confirm.
AMIBIOS SIMPLE SETUP UTILITY - VERSION 1.24b
(C) 2001 American Megatrends, Inc. All Rights Reserved
STANDARD CMOS SETUP
BIOS FEATURES SETUP
CHIPSET FEATURES SETUP
POWER MANAGEMENT SETUP
PNP / PCI CONFIGURATION
LOAD BIOS DEFAULTS
LOAD SETUP DEFAULTS
ESC: Quit ????? : Select Item
F6: Load BIOS Defaults
Re leas e:09 /16/ 99
INTEGRATED PERIPHERALS
HARDWARE MONITOR & MISC SETUP
SUPERVISOR PASSWORD
USER PASSWORD
Load Setup Defaults? (Y/N)?N
IDE HDD AUTO DETECTION
SAVE & EXIT SETUP
EXIT WITHOUT SAVING
(Shift)F2 : Change Color
F7: Load Setup Defaults
Load Setup Defaults
85
Appendix
F5: Old Values
F10:Save & Exit