Installing Memory Unit Typeb - Gestetner P7032 Setup Manual

Setting Up the Printer
I
Close the right cover by pushing
the area as shown in the illustra-
tion.
2
J
If the duplex unit is already in-
stalled, close the unit.
K
Slide the four mailbox trays into
the lower side of the mailbox
first.
Note
❒ After installing all options, print
a configuration page to confirm
the installation. If the new de-
vice is listed in the column of
configuration options, then it
has been properly installed. For
more information, see P.54
"Printing a Configuration Page".
40

Installing Memory Unit TypeB

Important
❒ The memory unit can be damaged
by small amounts of static electric-
ity. Before touching it, ground
yourself by touching something
metal to remove static electricity
from you.
Note
❒ If you want to install Memory Unit
ZAEP690E
TypeB and Printer Hard Disk Type
185, Memory Unit TypeB must be
installed first.
A
Confirm that the box contains the
following item.
• Memory unit
B
Turn off the printer, and remove
all cables and cords from the
printer.
C
Use a coin to remove the six
screws, and remove the printer
board cover.
Note
❒ The removed cover and screws
ZAEP360E
are required in step E.
ZDEP100E