Installing Options - Gestetner P7032 Setup Manual

Installing Options

R CAUTION:
• Before installing options, the machine should be turned off and unplugged
for at least thirty minutes. Components inside the machine become very
hot, and can cause a burn injury if touched.
• Before moving the machine, unplug the power cord from the outlet. If the
cord is unplugged abruptly, it could become damaged. Damaged plugs or
cords can cause an electrical or fire hazard.
• When lifting the machine, use the grips on both sides. The machine could
break or cause an injury if dropped.
You can increase the functionality of the printer by adding options. See "Op-
tions" in the Printer Reference included as a PDF file on the CD-ROM to confirm
what kind of options are available.
If you want to install options, options should be installed in the order described
below.
Important
❒ Rating voltage of the connector for options: max. DC 24 V.
Note
❒ If you want to install SR720 (1000-sheet finisher), Bridge Unit Type 320 and
PS420 or PS440 are required.
❒ If you want to install SR720 (1000-sheet finisher), contact your sales or service
representative.
Installing Options
2
17