Wall-Mount Installation; Tabletop To Wall-Mount Installation - AT&T EL52210 User Manual

Getting started

Wall-mount installation

The telephone base comes ready for tabletop use. If you want to mount your
telephone on a wall, use the provided wall-mount bracket to connect with
a standard dual-stud telephone wall-mounting plate. If you do not have this
mounting plate, you can purchase one from many hardware or consumer
electronics retailers. Professional assistance may be required to install the
mounting plate.

Tabletop to wall-mount installation

To change the telephone base from the tabletop installation to wall-mount
installation, make sure you first unplug the power adapter from the electrical
outlet and the telephone line cord from the telephone wall jack.
Plug one end of the telephone line cord into the TEL. LInE jack on the
1.
bottom of the telephone base. Plug the small end of the larger power
adapter into the power jack on the bottom of the telephone base.
2. Position the telephone base, as shown below. Insert the extended tabs of
the wall-mount bracket into the slots on the back of the telephone base.
Push the telephone base down until it clicks securely in place.
3. Route the telephone line cord through the wall-mount bracket hole. Route
the power cord out of the bottom of the telephone.
Slots for wall-mount
bracket installation
A DSL filter (not included) is
required if you have DSL
high-speed Internet service.
7