8.3 ACCESSORY CABLE
Wire Color/Description
WHITE - External Speaker ( + )
SHIELD - External Speaker (–)
RED - PA Speaker (+)
SHIELD - PA Speaker (–)
BLUE- NMEA Input (+)
GREEN - NMEA Input (–)
GRAY- NMEA Output (+)
BROWN-NMEA Output (–)
When connecting the external speaker or GPS navigation receiver, strip off
about 1 inch (2.5 cm) of the specified wire's insulation, then splice the ends
together using proper waterproofing techniques.
•
The GPS must have the NMEA Output turned on and set to 4800 Baud in
the setup menu. If there is a selection for parity select none.
•
For further information on interfacing /setting up your GPS. Please contact
the manufacturer of the GPS receiver.
•
GX3000S can read NMEA-0183 version 2.0 or higher.
•
The NMEA supported sentences are:
Input: GLL, GGA, RMC and GNS (RMC sentence is recommended)
Output: DSC and DSE
(DSC sentences to Standard Horizon Plotter for Position Polling)
If you have further inquires, please feel free to contact Product Support at:
Phone: (800) 767-2450
Email: marinetech@vxstdusa.com
GX3000S
Connection Examples
Connect to external 4 Ohm audio speaker
Connect to external 4 Ohm audio speaker
Connect to external 4 Ohm PA speaker
Connect to external 4 Ohm PA speaker
Connect to NMEA (+) output of GPS
Connect to NMEA (–) output of GPS
Connect to NMEA ( + ) input of GPS
No connection
Shield
Red
( )
Blue
NMEA OUT
( )
Green
NMEA OUT
( )
Gray
NMEA IN
Shield
White
FCC ID: K6630143X3D/IC ID: 511B-30143X3D
PA Speaker
GPS Receiver
External Speaker
Page 11
Vertex Standard Co., Ltd.