8.4
ACCESSORY CABLE
Wire Color/Description
WHITE - External Speaker ( + )
SHIELD - External Speaker (–)
RED - PA Speaker ( + )
SHIELD - PA Speaker (–)
GREEN - NMEA Ground
BLUE- NMEA Input (+)
GRAY-NMEA Output (+)
When connecting the external speaker or GPS navigation receiver, strip off
about 1 inch (2.5 cm) of the specified wire's insulation, then splice the ends
together.
•
The GPS must have the NMEAut turned on and set to 4800 Baud in
the setup menu. If there is a selection for parity select none.
•
For further information on interfacing /setting up your GPS. Please contact
the manufacturer of the GPS receiver.
•
GX2000/GX2100 can read NMEA-0183 version 2.0 or higher.
•
The NMEA supported sentences are:
Input: GLL, GGA, RMC and GNS (RMC sentence is recommended)
Output: DSC and DSE
(DSC sentences to Standard Horizon Plotter for Position Polling)
If you have further inquires, please feel free to contact Product Support at:
Phone: (800) 767-2450
Email: marinetech@vxstdusa.com
GX2000/GX2100
Connection Examples
Connect to external 4 Ohm audio speaker
Connect to external 4 Ohm audio speaker
Connect to external 4 Ohm PA speaker
Connect to external 4 Ohm PA speaker
Connect to NMEA (–) connection of GPS
Connect to NMEA ( + ) output of GPS
Connect to NMEA ( + ) input of GPS
16/9
WX
SCAN
QUANTUM
GX5000S
NAV
IC
PA/
DW
H/L
FOG
DISTRESS
MENU
CALL
ENT
CLR
Shield
Red
VOL/PWR
Blue
Green
Gray
SQL
Shield
PULL OPEN
White
PA Speaker
( )
NMEA OUT
( )
NMEA OUT
( )
NMEA IN
GPS Receiver
External Speaker
Page 15