Danby DPA060C2WDB Owner's Use And Care Manual page 17

Operating Instructions
AIR CONDITIONING
Important: The exhaust hose must be properly vented outdoors during air conditioning mode.
1. Press the POWER SWITCH key
temperature display area of the display panel.
2. Press the MODE key
vance to a different mode setting (Cool, Dehumidifi er, Fan).
3. Press the appropriate increase or decrease buttons
Temperature settings are adjustable between 16°C (61°F) to 30°C (86°F).
4. Press the Fan key
pression of the fan key will advance to a different setting).
• Cooling stops automatically when the set temperature is achieved. Cooling resumes when the room temperature rises
above the "set" temperature level.
DEHUMIDIFIER
Note: During dehumidifi er mode, the exhaust hose has to be vented outdoors.
1. Press the ON/OFF
2. Press the MODE key
will advance to a different mode setting (Cool, Dehumidifi er, Fan).
Note: The warm air exchange hoses must vent outside the room when using dehumidifi er mode.
FAN
Note: During fan mode, the exhaust hose does not have to be vented outdoors.
1. Press the POWER SWITCH
2. Press the MODE key
will advance to a different mode setting (Cool, Dehumidifi er, Fan).
3. Press the FAN KEY
trol. Each press of the fan key will advance to a different fan speed (High, Med., Low) as shown below.
Low Speed
Medium Speed
High Speed
NOTE: The fan is a continuously running fan and will not shut off when the unit is operating. This is to ensure
that the unit operates as effi ciently as possible.
POWER OUTAGE
to switch on the unit, and the previous set temperature will be shown in the
until the COOL indicator light illuminates. Each depression of the MODE key will ad-
to select the desired fan speed setting. Your selection will appear on the display (each de-
key pad to switch the unit on.
until the DRY indicator illuminates on the display panel. Each press of the MODE key
key to turn the unit on.
until the FAN indicator illuminates on the display panel. Each press of the MODE key
to select the desired FAN SPEED setting. Your selection will appear on the remote con-
AUTO
In the case of a power outage or interruption, the unit will automatically re-start with
the default settings after the power is restored.
Wait 3 minutes before resuming operation
After the unit has stopped, it cannot operate for the fi rst 3 minutes. This is to protect
the unit. Operation will automatically start after 3 minutes.
to select a suitable operating temperature setting.
13