Table of Contents
Advertisement
List of Functions
"Reading error notification mail"
s
Submenu
Set to On to send an email to the preset addresses when a problem
Mail Notification
or warning occurs with a projector.
You can input the IP Address
SMTP Server
projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
Port Number
You can input the port number for the SMTP server. The default
value is 25. You can input numbers between 1 to 65535.
Enter the email address of the sender. You can enter up to 64
From
single-byte alphanumeric characters. You can enter up to 32
characters on the Configuration menu. When entering more
than 32 characters, use your Web browser to enter the text.
( " ( ) , : ; < > [ \ ] and spaces cannot be used.)
s "Changing Settings Using a Web Browser (Epson Web
Control)"
p.218
p.227
Function
g
for the SMTP server for the
Submenu
Address 1 Set-
Set the destination email addresses for the notification email, and
ting/Address 2
the notification content. You can register up to three
Setting/Address
destinations. You can enter up to 64 single-byte alphanumeric
characters. You can enter up to 32 characters on the
3 Setting
Configuration menu. When entering more than 32 characters,
use your Web browser to enter the text. ( " ( ) , : ; < > [ \ ] and spaces
cannot be used.)
s "Changing Settings Using a Web Browser (Epson Web
Control)"
p.218
Set to On to monitor the projector using SNMP
SNMP
the projector, you need to install the SNMP manager program on
your computer. SNMP should be managed by a network
administrator. The default value is Off.
Trap IP Address
You can register up to two IP addresses for the SNMP trap
1/Trap IP Ad-
notification destination.
dress 2
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
Community
Set the community name of SNMP. You can enter up to 32 single-
Name
byte alphanumeric characters. (Spaces and symbols cannot be
used.)
Set this to On to use the PJLink notification function.
PJLink Notifica-
tion
Enter the IP address of the computer to which you want to send
Notified IP Ad-
dress
notifications of the projector's operating status using the PJLink
notification function.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
163
Function
g
. To monitor
Advertisement
Table of Contents
