Bosch HIIP055C Use And Care Manual page 44

Open the oven door to its fully open position.
1.
Flip levers on hinges toward you.
2.
Note: It may be necessary to use a tool, such as a
screwdriver, to gently pry the upper part of the lever
away from the housing. Take care to avoid scratching
the housing.
Bring both door hinge levers to their fullest down
3.
position as shown in the illustration. The left and right
door hinges differ slightly but operate in the same
manner.
Close the oven door until it catches on the hinge stop
4.
levers, locking the hinges at the proper angle for door
removal. The door will be open about 7 inches at the
top. This takes the spring tension off the hinges so the
door can be easily lifted out.
The door is heavy. Use both hands to firmly grip it by
5.
the sides. Do not grip the door by the handle.
Maintaining the door angle, lift the door straight up
approximately 3/4" to unhook the hinges from the
slots and then pull it out towards you until the hinges
are clear of the oven housing.
Place the door in a convenient and stable location for
6.
cleaning.
44
How to Replace the Oven Door
Holding the door firmly in both hands, grip it on either
1.
side, not by the handle.
Tilt the door back slightly towards you until it opens
2.
about 7 inches at the top.
Slide the hinges into the slots as far as they will go and
3.
then lower the door straight down. The angle of the
door may need to be adjusted slightly to allow the
hinges to engage properly and the door to lower into
place. The door should lower about 3/4" and stop. If
not, the hinges have not engaged properly and the
door could fall if it is released.
Once both hinges are fully engaged as described in
4.
Step 3, gently open the door until it is fully open.
Push the levers on both the hinges up and forward
5.
until they are locked into the slot and flush with the
front of the oven body.
Close and open the door slowly to be sure it is
6.
correctly and securely in place.