Bosch HIIP055C Use And Care Manual page 13

Inserting Racks
CAUTION
9
To avoid burns, place oven racks in desired
▯
positions before turning oven on. Always use
oven mitts when the oven is warm. If a rack must
be moved while the oven is hot, do not let oven
mitts contact hot heating elements.
Use caution when removing oven racks from the
▯
lowest rack position to avoid contact with the hot
oven door.
To avoid possible injury or damage to the
▯
appliance, ensure racks are installed exactly per
installation instructions and not backwards or
upside down.
Flat Rack
The rack is designed with a stop so it will stop before
coming completely out of the oven and not tilt.
To insert Flat Rack into Oven:
Grasp rack firmly on both sides.
1.
Insert rack (see picture).
2.
Tilt rack up to allow stop into rack guide.
3.
Bring rack to a horizontal position and push the rest of
4.
the way in.
Rack should be straight and flat, not crooked.
To remove Flat Rack from Oven:
Grasp rack firmly on both sides and pull rack toward
1.
you.
When the stop is reached, tilt rack up and pull the rest
2.
of the way out.
Telescopic Rack
To insert Telescopic Rack into Oven:
Slide the rack in evenly until the rear of the rack is
1.
about two (2) inches from the back of the oven.
Tilt the front of the rack up about 3/4" (A) and finish
2.
pushing the rack all the way back (B).
Note: Avoid striking the oven light cover glass when
pushing the rack into position.
The back of the telescopic rack drops in to place.
3.
Pull the rack forward to engage the bottom of the rack
4.
onto the rear of the rack position guide.
Lower the front of the rack to finish seating it on the
5.
rack guide. The rack should feel stable when properly
seated.
Slide the movable part of the telescopic rack in and
6.
out a few times to make sure it is able to move freely
and that the non-moving part of the telescopic rack is
securely anchored.
CAUTION
9
To avoid possible injury or damage to the
appliance, ensure the telescopic rack is installed
exactly per installation instructions and not
backwards or upside down.
To Remove Telescopic Rack from the Oven:
Lift the front of the telescopic rack assembly about 1/
1.
2" and push the rack to the rear about 3/4". This
allows the rack to disengage from the rack position
guide.
Lift the rear of the telescopic rack assembly so it
2.
clears the rack position guide and gently pull the rack
from the oven.
Note: Take care to avoid pulling the rack unevenly
which will cause it to bind during removal, catching on
the oven walls.
13