Table of Contents
Advertisement
9 Other features
Set the alarm timer
This unit can be used as an alarm clock. You can
select disc, radio or USB as alarm source.
1
Make sure that you have set the clock
correctly.
2
Press and hold SLEEP/TIMER for more
than two seconds.
» 'TIMER SET' is displayed. Then, a
prompt to select the sound source is
displayed.
3
Press SOURCE to select a source from
DISC, USB and FM, then press SLEEP/
TIMER to confirm.
» In 12 hour format, AM or PM is
displayed. In this case, press
select AM or PM. Then the hour digits
are displayed and begin to blink.
» In 24 hour format, the hour digits are
displayed and begin to blink.
4
Press
/
repeatedly to set the hour,
then press SLEEP/TIMER to confirm.
» The minute digits are displayed and
begin to blink.
5
Press
/
repeatedly to set the minute,
then press SLEEP/TIMER to confirm.
» A prompt to select the volume level is
displayed.
6
Press VOL +/- to select the desired
volume level, then press SLEEP/TIMER to
confirm.
» The alarm timer is set and activated.
18
EN
To deactivate or re-activate an alarm timer
•
•
In BT, AUDIO IN or AUX IN mode, the alarm timer
cannot be set.
•
If the disc or USB source is selected but no audio file
can be played, FM radio is activated automatically.
Set the sleep timer
This unit can switch to standby automatically
after a set period of time.
•
/
to
To deactivate sleep timer
•
Restore default settings
You can also restore the default settings of the
unit.
•
In standby mode, press SLEEP/TIMER
repeatedly.
» When the alarm timer is deactivated,
''TIMER OFF is displayed.
» When the alarm timer is re-activated,
'TIMER ON' is displayed.
Tip
When the unit is turned on, press SLEEP/
TIMER repeatedly to select a set period of
time (in minutes).
Press SLEEP/TIMER repeatedly until [OFF]
(off) is displayed.
In any mode, press and hold both
PRESET - on the front panel for more than
five seconds.
» After a while, 'RESET OK' is displayed.
Then, the device reboots automatically.
and
Advertisement
Table of Contents
