Table of Contents
Advertisement
TRENDnet User's Guide
Live View
Change the live view settings.
General
Live view general settings
Video Output
The video output interface is VGA or HDMI
Interface:
Live View Mode: Choose the default Live View mode to be 1x1 single
video on the screen or 2x2 four video on the screen at
the same time. Default: 2x2.
Dwell Time: Set up how long each display will be showed up on the
screen. There's no effect on 2x2 display mode. On 1x1
mode, each video will be shown on the screen for Dwell
Time and then change to the next video. Default: 10
seconds.
Enable Audio
Enable or disable audio output on the NVR. Default:
Output:
disabled
© Copyright 2018 TRENDnet. All Rights Reserved.
Event Output: Define where the video is going out when event
triggered. The NVR is set to both VGA and HDMI.
Full Screen
When event triggered full screen display, who long the
Monitoring
video is going to stay on the screen. Default: 10
Dwelling Time:
seconds.
Click Apply to apply the changes.
View
Setting live view display arrangement and sequence.
Camera
List
Control
Panel
Live View Layout and Sequence Settings
Video Output
The video output interface is VGA or HDMI
Interface:
Camera List: Installed cameras will be listed here by channel.
Layout Panel: Preview how the layout the video display.
TV‐NVR408
42
Advertisement
Table of Contents
