Connecting The Power Cord - Sharp Conference Series Operation Manual

Controlling the Projector by a Computer (Continued)
When connecting to the LAN terminal using a LAN cable
Note
• When connecting to a hub, use a straight-through Category 5 (CAT.5) type cable (commercially
available).
• When connecting to a computer, use a cross-over Category 5 (CAT.5) type cable (commercially
available).

Connecting the Power Cord

Plug the supplied power cord into the AC
socket on the rear of the projector. Then
plug into AC outlet.
26
LINK LED (green)
Illuminates when linked.
TX/RX LED (yellow)
Illuminates when transmitting/receiving data.
* To ensure safety, do not connect the LAN terminal
with any cables that may cause excessive voltage
such as a telephone line.
To LAN terminal
LAN cable (Category 5 type,
commercially available)
Hub
or
Computer
AC socket AC socket
Power cord (supplied) Power cord (supplied)
To AC outlet To AC outlet