Controlling The Projector By A Computer; Connecting The Power Cord - Sharp XR-H825XA Manual

Controlling the Projector by a Computer

When the RS-232C terminal on the projector is connected to a computer with a DIN-D-sub RS-
232C adaptor (optional, AN-A1RS) and an RS-232C serial control cable (cross type, commercially
available), the computer can be used to control the projector and check the status of the projector.
See page 57 for details.
When connecting to a computer using an RS-232C serial control cable and a DIN-
D-sub RS-232C adaptor
• The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the
operation manual of the computer for details.
56
• See page for connection of an RS-232C serial control cable.
• Do not connect the RS-232C cable to a port other than the RS-232C terminal on the computer. This
may damage your computer or projector.
• Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on.
This may damage your computer.

Connecting the Power Cord

Plug the supplied power cord into the
AC socket on the rear of the projector.
Then plug into AC outlet.
24
To RS-232C terminal
DIN-D-sub RS-232C
adaptor (optional, AN-A1RS)
RS-232C serial control cable (cross type, commercially available)
To RS-232C terminal
AC socket
To AC outlet
Computer
Power cord
(supplied)