Char-Broil 463262811 Product Manual page 19

9
Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and
facing the front. Secure using two 1/4-20x1½" screws, 7mm lock washers, and 7mm flat washers on each side.
NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN
ASSEMBLED TO CART.
10
First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner
valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes
on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on
fascia. Attach using two #8-32x3/8" screws and 4mm lock washers. Press sideburner control knob onto valve stem.
Screws and Washers
removed from valve bracket
Valve stem
Install bezel with "OFF" at top.
Note: Use left and right
holes on fascia to
attach valve bracket
Control knob
Sideburner
fascia
Sideburner
valve bracket
7mm flat
washer
Note: Use upper and lower
holes on fascia to
#8-32x3/8" screw
Control knob
bezel
1/4-20x1½"
screw
7mm lock
washer
attach bezel
4mm
lock washer
19