Installation Menu - BenQ HT9060 User Manual

• 3D Sync Invert
When your 3D image is distorted, enable this function to switch between the image
for the left eye and the right eye for more comfortable 3D viewing experience.
3D
(Continued)
• 3D Switch Reminder
Displays a message during the projector start-up to remind that it is necessary to
turn on the 3D function if you want to enjoy 3D contents.
The projector supports HDR imaging sources. It can automatically detect the
dynamic range of the source, and optimize settings to reproduce contents under
HDR wider dynamic range. Meanwhile, the Picture Mode cannot be adjusted after
switching to HDR. If the input source is not defined with dynamic range, you can
also manually select HDR10, HLG, or SDR for it.

INSTALLATION menu

Projector The projector can be installed on a ceiling or behind a screen, or with one or more
mirrors. See
Position
Adjusts the image size and focus and check that the
projected image is free from distortion.
Test Pattern
There are several options to set the image's aspect ratio depending on your input
signal source.
• Auto: Scales an image proportionally to fit the
• Real: Projects an image as its original resolution and
Aspect Ratio
• 4:3: Scales an image so that it is displayed in the center
• 16:9: Scales an image so that it is displayed in the
• 2.4:1: Scales an image so that it is displayed in the
Choosing a location on page
projector's native resolution in its horizontal or vertical
width.
resizes it to fit within the display area. For input signals
with lower resolutions, the projected image will be
displayed in its original size.
of the screen with a 4:3 aspect ratio.
center of the screen with a 16:9 aspect ratio.
center of the screen with a 2.4:1 aspect ratio.
11.
15:9 picture
4:3 picture
16:9 picture
4:3 picture
16:9 picture
16:9 picture
Menu operation 29