Table of Contents
Advertisement
Printing on special media
8
Transparency
To avoid damaging the machine, use only transparencies designed for use in
laser printers.
• In case of color printing using transparencies, the picture quality would
be lower than mono printing when the printouts are used on the
overhead projector.
•
Transparencies used in the machine must be able to withstand the
machine's fusing temperature.
•
Place them on a flat surface after removing them from the machine.
•
Do not leave unused transparencies in the paper tray for long periods of
time. Dust and dirt may accumulate on them, resulting in spotty printing.
•
To avoid smudging caused by fingerprints, handle them carefully.
•
To avoid fading, do not expose printed transparencies to prolonged
sunlight.
•
Ensure that transparencies are not wrinkled, curled, or have any torn edges.
•
Do not use transparencies that separates from the backing sheet.
•
To prevent transparencies from sticking to each other, do not let the printed
sheets stack up as they are begin printed out.
•
Recommended media: Transparency for a color laser printer by Xerox, such
as 3R 91331(A4), 3R 2780(Letter).
•
Prints made on transparency film with this printer are not compatible with
overhead projectors and may appear as a black and white image if
projected.
9
Labels
Load the paper with the side to be printed on facing down.
To avoid damaging the machine, use only labels designed for use in laser
machines.
•
When selecting labels, consider the following factors:
-
Adhesives: The adhesive material should be stable at your machine's
fusing temperature of about 170°C (338 °F) for 0.1 second.
65
2. Media and Tray
Advertisement
Chapters
Table of Contents
