Setting Surface Controls; Hot Surface Indicator - LG LSES302ST Owner's Manual

SETTING SURFACE CONTROLS

Use to operate the surface elements. The control knobs can be set anywhere between HI and LO.
➊ Place pan on surface element.
➋ Push in and turn the knob in either direction to the
desired heat setting.
NOTE:
The Control Panel is marked
to identify where the
element is.

HOT SURFACE INDICATOR

A Hot Surface indicator light will glow when
the surface is too hot to touch because of
the heating element. It will remain on after
the element is turned off and the surface
has cooled to approximately 150 deg F.
USING THE ELEMENT
To turn on a SINGLE
2 2
surface unit:
(Left Rear, Right Rear)
1
➊ Push the knob in.
➋ Turn the knob in either direction to the setting you
want.
The control knob clicks when it Is positioned at
both OFF and HI.
2 2
1
2
2 2
1
1
CAUTION
• NEVER leave food unattended at high or medium-
high setting.
- Boil overs can cause smoke.
Greasy spillovers may catch on fire.
S U R FAC E C O N T RO L S C O O K I N G
2
2 2
1
➌ There are element indicator lights above the each
knob on the control panel. When any control knob
is turned on, the light will glow.
OFF
➍ After cooking, turn knob to OFF
CAUTION
• DO NOT touch surface elements until it has
cooled down sufficiently.
- The surface elements may still be hot and burns
may occur.
To turn on a DUAL surface unit:
2 2 2 2
(Left Front)
2 2
1 1
There is one dual element located in the left front
A
position. This allows you to change the size of
element. 1
➊ Push the knob in.
➋-A Turn the knob counterclockwise to the
SINGLE surface unit settings.
➋-B Turn the knob clockwise to the DUAL surface
unit settings
2 2
A B
1
A
2
A
Heating with inner
(smaller)element only
A
A
A
ON
B
B
2 2
2
A B
B
1
1
Heating with both 2 2
elements together
1
B
B
B
A
11
2
1