Set Time Alarm; Activate/Deactivate Time Alarm; Snooze Alarm; Manually Set Time/Date: Program Menu - La Crosse Technology C83349 Manual

Explanation: When the indoor temperature is inaccurate, it is often due to the location of
the display or overpowered/under powered batteries. You can test the accuracy at you
home.
Side-by-side test: Bring the remote sensor in the house and place it next to the weather
station for 2 hours.
 Compare indoor and remote temperature. The temperature should be within 4 degrees
to be within tolerance.
 Look for heat sources such as sunlight, door or window frames or reflected heat or cold
near the weather station.
Check batteries and AC power

Set Time Alarm

In normal mode, hold the ALARM button for three seconds to enter alarm set mode.
1. HOUR: The Hour will flash, use the ▲ or ▼ buttons to set the hour, and press ALARM
button to confirm and switch to minutes.
2. MINUTES: The Minutes will flash, use the ▲ or ▼ buttons to set the minutes, and press
ALARM button to confirm and exit.
Note: When no buttons are pressed for ten seconds, the weather station will save the last
change and default back to normal mode

Activate/Deactivate time alarm

 In normal mode, press and release the ALARM button once to show alarm time.
 Press and release the ALARM button repeatedly to turn ON/OFF alarm.
 The alarm icon
 Note: The alarm will ring for 2 minutes then turn off if no buttons are pressed.

Snooze Alarm

 When the alarm sounds, press the HI/LOW/OFF button to snooze the alarm for 10
minutes.
 The snooze option can repeat three times.
 The alarm icon
 Note: while the alarm sounds press any button except the ALARM button to turn the
alarm off.

Manually Set Time/Date: Program Menu

The TIME SET button will move through the program menu. To change a value use the
ARROW buttons.
1. WWVB ON/OFF: Hold the TIME SET button five seconds so WWVB and the word ON
will flash. Press and release either ARROW button to turn this to OFF if you do not wish
WWVB time reception. Confirm with the TIME SET button and move to time zone.
2. TIME ZONE: EST will flash. Press and release the ▲ or ▼ buttons to select a different
Time Zone: AST=Atlantic, EST= Eastern, CST= Central, MST= Mountain, PST= Pacific,
AKT= Alaska, HAT=Hawaiian time zone. Confirm with the TIME SET button and move to
DST.
3. DAYLIGHT SAVING TIME: DST will flash and the word ON. Press and release the ▲ or
▼ buttons to turn this to OFF if you do not observe DST. Confirm with the TIME SET
button and move to 12/24 hour time.
La Crosse Technology, Ltd.
cord.
appears when alarm is active.
will flash while the snooze feature is active.
www.lacrossetechnology.com/support Page 10