Table of Contents
Advertisement
Fahrenheit/Celsius
Use the
program menu
Backlight
AC adapter: The backlight is on continuously when operating the weather station with the
5-volt AC adapter.
Note: When the AC adapter is NOT in use, the HI-LOW-OFF light feature is not available.
HIGH: The backlight is defaulted to HI at setup when the AC adapter is in use.
LOW: Press the HI-LOW-OFF button to dim the backlight.
OFF: Press the HI-LOW-OFF button again to turn off the backlight.
Press the HI-LOW-OFF button to return to full strength.
Note: When the backlight is off, press any button to activate the backlight for 10 seconds.
Battery power: When operating on battery power only, press and release the any button
and the backlight will show for 10 seconds.
Dashes, HH.H, LL.L or stuck Indoor Temperature/Humidity
Explanation: These symbols are error messages indication the indoor sensor is outside of
its readable range. For indoor readings, this is generally a power related issue.
Check that the AC power cord is inserted into a working outlet.
Batteries
may be overpowered or underpowered. Remove batteries from the weather
station.
Press any button 20 times. Leave the weather station unpowered for 1-2 hours.
Install fresh Alkaline batteries with correct polarity.
If the indoor temperature is still shows dashes, HH.H or LL.L, the weather station may
need replacement.
Inaccurate Indoor Temperature Reading
Explanation: When the indoor temperature is inaccurate, it is often due to the location of
the display or overpowered/under powered batteries. You can test the accuracy at your
home.
Side-by-side test: Bring the remote sensor in the house and place it next to the weather
station for 2 hours.
Compare indoor and remote temperature. The temperature should be within 4 degrees
to be within tolerance.
Look for heat sources such as sunlight, door or window frames or reflected heat or cold
near the weather station.
Check
batteries
and AC power
Set Time Alarm
In normal mode, hold the ALARM button for three seconds to enter alarm set mode.
1. HOUR: The Hour will flash, use the ▲ or ▼ buttons to set the hour, and press ALARM
button to confirm and switch to minutes.
2. MINUTES: The Minutes will flash, use the ▲ or ▼ buttons to set the minutes, and press
ALARM button to confirm and exit.
Note: When no buttons are pressed for ten seconds, the weather station will save the last
change and default back to normal mode
Activate/Deactivate time alarm
La Crosse Technology, Ltd.
to switch between Fahrenheit and Celsius.
cord.
www.lacrossetechnology.com/support
Page 9
Advertisement
Table of Contents
