Dashes, HH.H, LL.L or stuck Indoor Temperature/Humidity
Explanation: These symbols are error messages indication the indoor sensor is outside
of its readable range. For indoor readings, this is generally a power related issue.
• Check that the AC power cord is inserted into a working outlet.
•
Batteries
may be overpowered or underpowered. Remove batteries from the
weather station.
• Press any button 20 times. Leave the weather station unpowered for 1-2 hours.
• Install fresh Alkaline batteries with correct polarity.
• If the indoor temperature is still shows dashes, HH.H or LL.L, the weather station
may need replacement.
Inaccurate Indoor Temperature Reading
Explanation: When the indoor temperature is inaccurate, it is often due to the location
of the display or overpowered/under powered batteries. You can test the accuracy at
you home.
Side-by-side test: Bring the outdoor sensor in the house and place it next to the
weather station for 2 hours.
• Compare indoor and outdoor temperature. The temperature should be within 4
degrees to be within tolerance.
• Look for heat sources such as sunlight, door or window frames or reflected heat
or cold near the weather station.
Check
batteries
and AC power
Set Time Alarm
In normal mode, hold the ALARM button for three seconds to enter alarm set mode.
1. HOUR: The Hour will flash, use the ▲ or ▼ buttons to set the hour, and press
ALARM button to confirm and switch to minutes.
2. MINUTES: The Minutes will flash, use the ▲ or ▼ buttons to set the minutes, and
press ALARM button to confirm and exit.
Note: When no buttons are pressed for ten seconds, the weather station will save the
last change and default back to normal mode
Activate/Deactivate time alarm
• In normal mode, press and release the ALARM button once to show alarm time.
• Press and release the ALARM button repeatedly to turn ON/OFF alarm.
• The alarm icon
• Note: The alarm will ring for 2 minutes then turn off if no buttons are pressed.
Snooze Alarm
La Crosse Technology, Ltd.
cord.
appears when alarm is active.
www.lacrossetechnology.com/support
Page 12