Table of Contents
Advertisement
POSITIONING THE OUTDOOR TEMPERATURE TRANSMITTER
The outdoor temperature transmitter can be mounted in two ways:
•
with the use of screws
•
using the adhesive tape.
MOUNTING WITH SCREWS
MOUNTING WITH ADHESIVE TAPE
TROUBLESHOOTING
Problem:
The LCD is faint.
1) Replace the batteries.
Solution:
Problem:
No reception of WWVB signal
1) It may help reception to face the front of the atomic clock in the general
Solution:
2) Wait overnight for signal.
3) Be sure the atomic clock is at least 6 feet (2 meters) from any electrical
1)
Remove the mounting bracket from the outdoor temperature
transmitter.
2)
Place the mounting bracket over the desired location. Through the
three screw holes of the bracket, mark the mounting surface with a
pencil.
3)
Where marked, start the screw holes into mounting surface.
4)
Screw mounting bracket onto the mounting surface. Ensure that the
screws are flush with the bracket.
1) With a nonabrasive solution, clean and dry the back of the mounting
bracket and the mounting surface to ensure a secure hold. The
mounting surface should be smooth and flat.
2) Remove the protective strip from one side of the tape. Adhere the
tape to the designated area on the back of the mounting bracket.
3) Remove the protective strip from the other side of the tape. Position
the outdoor temperature transmitter in the desired location, ensuring
that the atomic clock can receive the signal.
direction of Ft. Collins, Colorado.
devices, i.e. TV sets, computers, or other radio controlled clocks.
15
Advertisement
Table of Contents
