Setting The Parking Sensor Interrupt On/Off; Rear Seat Entertainment Setup; Remote Sensor Setting; Unit Setup - Alpine INE-W710D Owner's Manual

Setting the Parking Sensor Interrupt On/Off

Set to "On" to display the Parking Assist screen if a vehicle detects an
obstacle.
Setting item:
Parking sensor interrupt
Setting contents:
Off / On (Initial setting)
• For details, see "About Vehicle Interlock Function" (page 86).

Rear Seat Entertainment Setup

[Rear Seat Entertainment] is selected on the System Setup Menu screen
in step 1. See "System Setup" (page 44).
When a Rear monitor equipped with HDMI input is connected to this
unit, change this setting to "On. " You can output images to the Rear
monitor. For details, see "Rear Seat Entertainment Function" (page 18).
Setting item:
Rear Seat Entertainment
Setting contents:
Off (Initial setting) / On
• When this setting is "On, " you can use this unit to switch the
Illumination of a Rear monitor with the Illumination function.
Setting the Rear Seat Entertainment System
Make sure the Rear Seat Entertainment is set to "On" (
Seat Entertainment Setup" (page 47).
Setting item:
Illumination Colour
Setting contents:
Off (Initial setting) / On
• For details on adjusting Illumination, see "Rear Seat Entertainment
Function" (page 18).
• When the Rear Seat Entertainment setting is set to "Off, " you cannot
select this item.
• Set the coordination colour controls on the Rear monitor to "Navi. "
When set to "Rear monitor, " you cannot operate them from this unit.

Remote Sensor Setting

Make sure the Rear Seat Entertainment is set to "On" (
Seat Entertainment Setup" (page 47).
For remote control operation, the remote sensor of the external device
(Rear monitor, etc.) can be switched, as you prefer.
Setting item:
Remote Sensor
Setting contents:
Front (Initial setting) / Rear
Front:
Rear:
• You can also control this setting from the Rear Seat Entertainment
System Setup screen. For details, see "Rear Seat Entertainment
Function" (page 18).

Unit Setup

[Unit] is selected on the System Setup Menu screen in step 1. See
"System Setup" (page 44).
Make this setting when you use an external audio processor.
). See "Rear

Setting the External AP

When using an external audio processor, set to "On" (
Setting item:
External AP
Setting contents:
Off (Initial setting) / On
• When this setting is "On, " the Volume level is fixed at 10. Also, Balance/
Fader/Subwoofer Level/Subwoofer Phase/Bass/Treble/MX HD/EQ
Presets/Dual HD EQ/X-OVER/Time Correction/Defeat/Phone
Speaker/Default Sound Settings are set to "Off " or "Flat" and cannot be
adjusted.
• Use the external AP to adjust volume.
The remote sensor of this unit is effective.
The remote sensor of Rear monitor is effective.
). See "Rear
).
47
-EN