Pc Connection - Panasonic Palmcorder Multicam PV-L672 Operating Instructions Manual

PC Connection

Digital PhotoShot Software
A live or captured image can be transferred
to your PC (Personal Computer).
System Requirements for Digital PhotoShot
• IBM PC/AT or compatible.
 
• Intel Pentium Processor.
 
• Microsoft Windows 95 or Windows

Windows Me or Windows
• RAM: 16 MB or more.
• 2 MB of available hard-disk space.
PC-Camcorder Connection
Connect Camcorder PC jack to the serial
port on your PC (Personal Computer) using
the supplied PC connector cable.
Refer to PC or Windows manual to identify
which COM port to be used for connection.
Note:
• Be sure to turn PC off before connection
for proper image transfer.
• After Camcorder and PC are connected
by starting up the software included,
video recording is not possible.
Software Installation
(Windows 95/98/Me/2000)
Before you begin...
• Your PC is in the power on mode.
1
Turn on PC (Personal Computer) and
start up Windows.
2
Insert Digital PhotoShot disk
(Windows 95/98/Me/2000) into a floppy
disk drive.
3
Click on Start, then "Run..."
4
Type in "a:\setup.exe" and click OK.
• If your 3.5 inch floppy disk drive is not
"A", use appropriate letter.
5
Follow instructions as they appear on PC
screen until the installation is complete.
• Setup window will disappear when the
installation is complete.
42
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com

98 or

2000.
Before you begin...
• Turn your PC off.
• Set Camcorder POWER to OFF.
• 256 color monitor (full color recommended).
• 3.5 inch 1.44 MB floppy disk drive (for installation).
• RS-232C serial port (D-Sub 9-pin).
An adaptor (D-Sub 9-pin male to a D-Sub
female) is required for a D-Sub 25-pin.
• Mouse or other pointing device.
RS-232C
Serial Port
(Default is
COM1)
(D-Sub 9-pin)
PC Connector
cable (supplied)
PC Connector