Panasonic Palmcorder Multicam PV-L672 Operating Instructions Manual page 36

Digital Still Camera
Recording
1
3
4
Note:
• If Memory Card is not inserted, "NO
CARD" appears on-screen.
Set POWER to OFF, then insert the
Memory Card.
• If "CARD ERROR" appears on-screen,
see page 56.
• Sound will not be recorded.
• The features below are not available
while in PHOTO mode.
• Auto Fade
• Color Digital Filter
• Digital E.I.S.
• MotionSensor
• Digital Wipe Mode
• Picture in Picture Wipe Title
36
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
2
• Digital Fade
• Digital Zoom
• Still/Strobe/Wide
Before you begin...
• Connect Camcorder to power source.
• Insert the Memory Card (optional, page 34).
1
Press LCD-OPEN and swing LCD
monitor fully open. Adjust viewing angle.
2
Set POWER to
PHOTO.
• Be sure POWER is
fully rotated to
PHOTO position.
3
Press MENU for
REC MODE menu.
Press UP or DOWN
to select NORMAL
or FINE (page 49).
Then, press
DISPLAY to set.
4
Press RECORD/PAUSE to capture
image.
• As the image is processed, the status
screens below appear.
The next image may be captured after
"COMPLETED" disappears.
• Depending on the image taken, the
image page remaining indication may
not change, or it may be decreased by
2 images.
• For sharper images, set electronic
shutter to higher speed when shooting
in bright conditions, such as outdoors.
WARNING:
Do not, under any circumstances, remove
the card immediately after pressing the
RECORD/PAUSE (during recording of an
image) or while deleting. This could
damage the format of the card and make
it unusable.