Projecting; Selecting The Input Signal; How To Adjust The State Of The Image - Panasonic PT-LW321EA Operating Instructions (Functional Manual)

Projecting

Projecting
Check the connections of the peripheral devices and connection of the power cord (
power ( page 29) to start the projector. Select the image and adjust the state of the image.
Æ

Selecting the input signal

Select an input signal.
Press <INPUT> button on the control panel or the <INPUT>,
<COMPUTER>, <HDMI>, <VIDEO> button on the remote
control.
The image of the signal being input in the selected terminal is
z
projected.
Press <INPUT> button to display the [Source] menu. Press
z
▲▼ to select the desired input and press ► to enter.

How to adjust the state of the image

1 ) Adjust the projection angle.
Place the projector parallel to the screen, and then install it on a flat surface so that the screen becomes
z
rectangle.
If the image is tilted lower than the screen, extend the adjustable feet to make a rectangle screen.
z
For details, see "Adjusting the Projector's Height" (
z
2 ) Adjust the zoom and the focus.
Turn the zoom lever and the focus ring to adjust the image.
Note
It is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.
z
As the projection screen size changes if the focus ring is turned, turn the zoom lever to fine-tune the projection screen size
z
again.
If keystone distortion occurs, see [V Keystone] in the [Position] menu (
z
30
- ENGLISH
page 24).
Æ
Zoom Lever
Focus Ring
Æ page 39).
page 27) and switch on the
Æ