Maytag MVWB835DW4 Use & Care Manual page 19

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/product_help –
If you experience
Error Code Appears in Display
"LF" (F8E1) (too long
to fill) appears in display
F#E# code (F-type error
code) appears in display
F1E1 ACU (Appliance
control fault)
F2E3 UI/ACU mismatch
F3E1 Water level sensing
failure
F5E2 Lid lock will not lock
if lid lock failure
F5E3 Lid cannot unlock
F6E2 or F6E3
Communication Error:
UI cannot communicate
F8E6 (Lid opened)
appears in display
"drn" "dr" (F9E1)
(drain pump system
problem – long drain)
appears in display
"Ofb" (Off Balance)
In Canada www.maytag.ca for assistance and to possibly avoid a service call.
Possible Causes
Washer taking too long to fill. Drain
extends more than 4.5" (114 mm)
into standpipe.
System error code.
Internal ACU failure.
ACU/UI initialization error.
Pressure sensor on ACU failure.
An item in the load may be keeping
the lid from locking.
Objects on washer lid prevent it from
unlocking.
ACU or UI synchronization error.
Washer lid left open.
Washer taking too long to drain water.
Drain extends more than 4.5" (114 mm)
into standpipe.
Load not balanced or evenly
distributed around the basket.
Check plumbing for correct drain hose installation. Use drain hose
form and attach securely to drainpipe or tub. Do not tape over drain
opening. See Installation Instructions.
Touch POWER to clear the code and exit cycle. Then touch
POWER, select cycle, and touch and hold the Start/Pause button
to start washer. If code appears again, call for service.
Call for service.
Call for service.
Call for service.
Check for items directly under the lid.
Remove objects, such as baskets of laundry, from top of washer.
Remove power from the washer. Let washer set for 5 minutes
for the washer to completely power down. Apply power to washer
and check for error codes. If the error code persists call for service.
Close the lid and touch POWER to clear the display. If the lid is left
open for more than 10 minutes, the cycle will reset and water in the
washer will drain.
Check plumbing for correct drain hose installation. Use drain hose
form and attach securely to drainpipe or tub. Do not tape over drain
opening.
Lower drain hose if the end is higher than 96" (2.4 m) above
the floor. Remove any clogs from drain hose. See Installation
Instructions.
Cycle is paused as indicated by the flashing Start/Pause
indicator. Open the lid, redistribute the load, and close the lid.
Touch and hold the Start/Pause button to resume.
Solution
19