Cautions; Connecting The Hob To The Mains Power Supply - Smeg SE232TD Instructions For Installation And Use Manual

Table of Contents

Under any circumstances, the brackets cannot touch with the inner surfaces of the

worktop after installation (see picture).

8.3 Cautions

1) The ceramic cooker hob must be installed by qualified personnel or technicians. We

have professionals at your service. Please never conduct the operation by yourself.

2) The ceramic cooker hob shall not be mounted to cooling equipment, dishwashers

and rotary dryers.

3) The ceramic cooker hob shall be installed such that better heat radiation can be

ensured to enhance its reliability.

4) The wall and induced heating zone above the work surface shall withstand heat.

5) To avoid any damage, the sandwich layer and adhesive must be resistant to heat.

6) A steam cleaner is not to be used.

7) This ceramic can be connected only to a supply with system impedance no more

than 0.427 ohm. In case necessary, please consult your supply authority for

system impedance information.

The power supply should be connected in compliance with the relevant standard, or a

single-pole circuit breaker. The method of connection is shown below.

1) If the cable is damaged or needs replacing, this should be done by an after-sales

technician using the proper tools, so as to avoid any accidents.

2) If the appliance is being connected directly to the mains supply, an omnipolar

circuit breaker must be installed with a minimum gap of 3mm between the

contacts.

3) The installer must ensure that the correct electrical connection has been made

and that it complies with safety regulations.

4) The cable must not be bent or compressed.

5) The cable must be checked regularly and only replaced by a properly qualified person.

The bottom surface and the power cord of the hob are not accessible after installation.

220 - 240 V~

EN-21

Table of Contents