Management Using Snmp; Esc/Vp21 Commands; Command List - Epson EB-G7905UNL User Manual

Monitoring and Controlling
• Lamp out
• Internal temperature error
• High-speed cooling in progress
• Lamp replacement notification
• Low Air Flow
• Low Air Flow Error
• No-signal
No Signal is input to the projector. Check the connection status or check
that the power for the signal source is turned on.
• Auto Iris Error
• Power Err. (Ballast)
• Incorrect projection mode
• Projection angle mismatch
• Lens shift error
See the following to deal with problems or warnings.
"Reading the Indicators"
s

Management Using SNMP

By setting SNMP to On in the Configuration menu, notification messages
are sent to the specified computer when a problem or warning occurs. This
will enable the operator to be notified of problems with projectors even at
locations away from the projectors.
Network - Notification - SNMP
s
p.164
p.151
a
• SNMP should be managed by a network administrator or someone
who is familiar with the network.
• To use the SNMP function to monitor the projector, you need to
install the SNMP manager program on your computer.
• The SNMP Agent for this projector complies with version 1
(SNMPv1).
• The managing function using SNMP cannot be used over wireless
LAN in Quick connection mode.
• Up to two destination IP addresses can be saved.

ESC/VP21 Commands

You can control the projector from an external device using ESC/VP21.

Command list

When the power ON command is transmitted to the projector, the power
turns on and it enters warm-up mode. When the projector's power has
turned on, a colon ":" (3Ah) is returned.
When a command is input, the projector executes the command and
returns a ":", and then accepts the next command.
If the command being processed terminates abnormally, an error message is
output and a ":" is returned.
The main contents are listed below.
Item
On
Power ON/OFF
Off
Signal selection Computer
208
Command
PWR ON
PWR OFF
Auto SOURCE 1F
RGB SOURCE 11
Component SOURCE 14